Technical Field Advisory

Paint Application Problems & Solutions

Optimal coating performance depends not just on paint formulation, but also on surface preparation, ambient conditions, and application technique. Refer to this practical troubleshooting guide to diagnose and eliminate defects.

Settling & Changes in Viscosity

Probable Cause:

Prolonged storage at improper temperatures, insufficient pigment dispersion, or vehicle-solvent incompatibility.

Corrective Measure:

Thoroughly re-mix using a mechanical stirrer from the bottom of the container. Store paints between 15°C and 30°C. Never exceed recommended thinner ratios.

Dry Spray & Cobwebbing

Probable Cause:

Using fast-evaporating thinners in hot weather, atomization pressure set too high, or holding spray gun too far from surface.

Corrective Measure:

Switch to a slower-evaporating solvent/retarder. Maintain gun distance at 15–20 cm perpendicular to substrate. Lower fluid and atomizing pressure.

Runs, Sags & Curtains

Probable Cause:

Excessive paint volume deposited per pass, over-thinning of paint, slow-evaporating solvent under cool conditions, or moving gun too slowly.

Corrective Measure:

Apply paint in uniform cross-hatch thin coats with proper flash-off times between coats. Check viscosity before application using a Zahn or Ford cup.

Blistering & Blowholes

Probable Cause:

Moisture or trapped solvents beneath the primer/filler layer, painting on porous substrates in direct sunlight, or premature force-drying.

Corrective Measure:

Ensure the substrate is thoroughly dry (< 4% moisture content) before painting. Seal porous surfaces with an appropriate penetrating primer.

Difference of Shade / Color Variation

Probable Cause:

Incomplete stirring of settled tints, uneven film thickness (DFT), or comparing colors under dissimilar light sources.

Corrective Measure:

Stir thoroughly before and periodically during application. Maintain consistent dry film thickness. Carry out color matching under standardized D65 daylight.

Poor Adhesion & Peeling

Probable Cause:

Contamination with oil, grease, rust, or mill scale. Smooth substrates without sufficient mechanical anchor profile.

Corrective Measure:

Degrease surfaces using solvent wash followed by blast cleaning or thorough mechanical wire brushing to achieve Sa 2.5 profile.